Bai Shui Chao
Email: dl-bsc@dlsjmj.com
Telephones: 13962423309
Mark Yen
Email: dl-mark@dlsjmj.com
Telephones: 17312472090
TEL:0512-57170368
FAX:0512-57170328
HTTP://www.kynsp.com
Add: No.218 South Yucheng Road Kunshan City Jiangsu Province China.
In precision injection molding, when two or more strands of melt fill the cavity, if the front part of the two or more strands of melt have cooled down when they meet, so that they can not fully fuse, a linear groove is created at the confluence, fo
First of all, dont just focus on product design, ignoring plastic mold manufacturing. Some users only pay attention to product development and development when developing trial products or new products, but neglect to communicate with plastic mold m
Under what conditions should the mold be heated by the mold heater and when should the plastic mold be cooled by the water cooler? Here are some conditions for injection molding. 1. mold pressing: in principle, it should be greater than the total pr
This article analyzes the installation and adjustment of injection moulds. Lets take a look at it. First, mold pre inspection: Inspection should be carried out before the injection molding machine is installed on the mold, so as to find out the qual
Plastic mold casting system can be divided into three categories according to different system types. (1) Door mold, gate and gate parting line, mold and stripping, the simplest design, easy processing, low cost, so more and more people use the door
The production of plastic mold products is first based on the development and design of plastic moulds. The accuracy directly affects the structural integrity and dimensional accuracy of plastic products. All kinds of plastic products are designed a
在線客服（fú）1